Skip to main content

Running

To run edgesec tool with the configuration file dev-config.ini located in ./build folder use:

./build/src/edgesec -c ./build/dev-config.ini

To enable verbose debug mode use:

./build/src/edgesec -c ./build/dev-config.ini -ddddd

The configuration file config.ini has been setup to work by default only when:

  • running on Raspberry Pi (e.g. wlan1 is the name of Wifi USB AP and eth0 is the ethernet port)
  • running after make install has been run
Running edgesec tool with debug info and master password 12345 (verbose)​
sudo CRYPT_KEY=12345 ./src/edgesec -c config.ini -ddddddddd